Juniper JN0-362 Exam Preparation Guide and PDF Download
Verified & Correct JN0-362 Practice Test Reliable Source Sep 25, 2022 Updated
NEW QUESTION 34
You have recently configured MSTP on two switches in your network to participate in the same MSTP region. You issue the show spanning-tree mstp configuration command on both switches and notice that the configuration digests do not match.
What does this mismatch indicate?
- A. You should ensure that the MSTIs and their VLAN IDs are equal on both switches.
- B. You should ensure that the bridge IDs and priority values are unique on both switches.
- C. Everything is functioning as expected because the configuration digests should not match.
- D. You should ensure that the max-age and hello timers are equal on both switches.
Answer: A
NEW QUESTION 35
What are tree types of interfaces that can be used in an MX Series device when implementing a virtual switch routing instance? (Choose three.)
- A. Access interface
- B. GRE tunnel interface
- C. Trunk interface
- D. Logical tunnel interface
- E. Layer 2 logical interface
Answer: A,C,E
NEW QUESTION 36
Click the Exhibit button. In the exhibit, all routers are sending routes to Router B.Which routes will be advertised from Router B to Router E?
- A. BGP routes learned from Router A only
- B. BGP routes learned from Router D only
- C. BGP routes learned from Routers A, C, and D only
- D. BGP routes learned from Routers A and C only
Answer: C
NEW QUESTION 37
Click the Exhibit button.
You are asked to configure OSPF for the network? Referring to the exhibit, how should Area 1 be configured?
- A. not-so-stubby area
- B. totally stubby area
- C. stub area
- D. backbone area
Answer: C
NEW QUESTION 38
Click the Exhibit button.
Referring to the exhibit, how many milliseconds must pass before the interface ge-0/0/1.0 is considered down?
- A. 1200 ms
- B. 1600 ms
- C. 2400 ms
- D. 900 ms
Answer: A
NEW QUESTION 39
What are two benefits of using an OSPF designated router (DR)? (Choose two.)
- A. Reduces LSA flooding throughout an OSPF area.
- B. Reduces LSA flooding on a broadcast segment.
- C. Reduces the size of the link-state database.
- D. Reduces router resources used.
Answer: B,D
NEW QUESTION 40
Click the Exhibit button. Based on the configuration shown in the exhibit, what will be the state of the IS-IS levels on interface ge-0/0/0.100?
- A. Level 1 is disabled and Level 2 is disabled.
- B. Level 1 is enabled and Level 2 is disabled.
- C. Level 1 is enabled and Level 2 is enabled.
- D. Level 1 is disabled and Level 2 is enabled.
Answer: A
NEW QUESTION 41
You are asked to change the default TTL handling behavior on your Junos device to ensure that the RSVP- signaled LSPs in your MPLS network cannot be mapped.
Which configuration should be performed to accomplish this task?
- A. Configure the no-propagate-ttl parameter for each LSP on the egress device
- B. Configure the no-propagate-ttl parameter for each LSP on the ingress device
- C. Configure the no-decrement-ttl parameter for each LSP on the ingress device
- D. Configure the no-decrement-ttl parameter for each LSP on the egress device
Answer: A
NEW QUESTION 42
Click the Exhibit button.
Referring to the exhibit, the GRE tunnel between R-1 and R-2 allows connectivity between User-1 and Server-1. When User-1 communicates with Server-2 with packets that are 1472 bytes in size, no packet fragmentation occurs. User-1 can communicate with Server-1 with packets that are up to 1448 bytes in size with no packet fragmentation. However, if the packet size is larger than 1448 bytes, packet fragmentation occurs.
Why is the packet fragmentation occurring between User-1 and Server-1 in this scenario?
- A. The IP header adds 24 bytes to the packet
- B. The GRE header adds 20 bytes to the packet
- C. The GRE header adds 24 bytes to the packet
- D. The IP header adds 20 bytes to the packet
Answer: C
NEW QUESTION 43
Which Layer 2 mechanism logically groups network nodes into separate broadcast domains?
- A. IP subnets
- B. OSPF areas
- C. IS-IS levels
- D. VLAN
Answer: D
NEW QUESTION 44
In an IS-IS network, which device represents the pseudo-node?
- A. an area border router
- B. a router with an IS-IS export policy
- C. a designated intermediate system
- D. a router connected to the backbone
Answer: C
NEW QUESTION 45
Which two statements are true about NSR? (Choose two.)
- A. NSR requires only one RE.
- B. NSR requires graceful restart to function properly
- C. NSR requires redundant REs.
- D. NSR requires GRES to function properly.
Answer: C,D
NEW QUESTION 46
Which two statements are true about IBGP on MX Series devices? (Choose two.)
- A. It is loop free by default
- B. Neighbors can be located anywhere within the AS
- C. Interface Lo0 must be used for peering
- D. It does not support multihop
Answer: A,B
NEW QUESTION 47
You are asked to design a Layer 2 VPN service between service provider networks that needs Ethernet transport capabilities. The VPN should support two or three endpoints. Which Layer 2 VPN technology should you propose?
- A. LDP-signaled VPLS
- B. BGP Layer 2 VPN
- C. BGP-signaled VPLS, using the RFC 4448 Layer 2 frame format
- D. LDP Layer 2 circuit, using the RFC 4448 Layer 2 frame format
Answer: C
NEW QUESTION 48
Click the Exhibit.
Referring to the configuration in the exhibit, which statement is true?
- A. The next-hop 172.16.1.2 must be directly connected to the router for route 192.168.5.0/24 to be active.
- B. The next-hop 172.16.1.2 must be part of an active route in route table inet.0 for route
192.168.5.0/24 to be active. - C. The next-hop 172.16.1.2 must be active in route table inet.3 for the route 192.168.5.0/24 to be active.
- D. The next-hop 172.16.1.2 must respond to ping commands for the route 192.168.5.0/24 to be active.
Answer: B
NEW QUESTION 49
Click the Exhibit button.
Referring to the exhibit, which statement is correct?
- A. R4 will be the designated router
- B. R1 will not participate in the election process
- C. R3 will not participate in the election process
- D. R2 will be the designated router
Answer: C
NEW QUESTION 50
Click the Exhibit.
Referring to the configuration shown in the exhibit, which statement is true?
- A. Traffic destined to address 192.168.5.1 will take next-hop 172.16.1.2.
- B. Traffic destined to address 192.168.5.1 will take next-hop 10.0.1.1.
- C. Traffic destined to address 192.168.5.1 will take next-hop 172.16.1.3.
- D. Traffic destined to address 192.168.5.1 will alternate between next-hops 172.16.1.2 and
172.16.1.3
Answer: C
NEW QUESTION 51
Click the Exhibit.
You have configured the IBGP group shown in the exhibit. However, committing your configuration fails.
Which parameter should you add to the IBGP group configuration to correct the problem?
- A. Type external
- B. As -override
- C. Type internal
- D. Export <policy name>
Answer: C
NEW QUESTION 52
......
Pass Juniper JN0-362 exam Dumps 100 Pass Guarantee With Latest Demo: https://www.guidetorrent.com/JN0-362-pdf-free-download.html