NSE7_SDW-7.2 Exam Dumps - Try Best NSE7_SDW-7.2 Exam Questions from Training Expert GuideTorrent Practice Examples and Dumps Tips for 2025 Latest NSE7_SDW-7.2 Valid Tests Dumps NEW QUESTION # 35 Refer to the exhibit.The device exchanges routes using IBGP.Which two statements are correct about the IBGP configuration and routing information on the device?(Choose two.) A. additional-path is enabled. B. [...]

NSE7_SDW-7.2 Exam Dumps - Try Best NSE7_SDW-7.2 Exam Questions from Training Expert GuideTorrent [Q35-Q50]

Share

NSE7_SDW-7.2 Exam Dumps - Try Best NSE7_SDW-7.2 Exam Questions from Training Expert GuideTorrent

Practice Examples and Dumps & Tips for 2025 Latest NSE7_SDW-7.2 Valid Tests Dumps

NEW QUESTION # 35
Refer to the exhibit.

The device exchanges routes using IBGP.
Which two statements are correct about the IBGP configuration and routing information on the device?
(Choose two.)

  • A. additional-path is enabled.
  • B. Each BGP route is three hops away from the destination.
  • C. ibgp-multipath is disabled.
  • D. You can run the get router info routing-table database command to display the additional paths.

Answer: A,D


NEW QUESTION # 36
Which two statements are true about using SD-WAN to steer local-out traffic? (Choose two.)

  • A. By default, FortiGate does not check if the selected member has a valid route to the destination.
  • B. By default, local-out traffic does not use SD-WAN.
  • C. You must configure each local-out feature individually, to use SD-WAN.
  • D. FortiGate does not consider the source address of the packet when matching an SD-WAN rule for local-out traffic.

Answer: B,C


NEW QUESTION # 37
Refer to the exhibits.
Exhibit A

Exhibit B

Exhibit A shows an SD-WAN event log and exhibit B shows the member status and the SD-WAN rule
configuration.
Based on the exhibits, which two statements are correct? (Choose two.)

  • A. Port2 has a lower latency than port1.
  • B. SD-WAN rule ID 1 is set to lowest cost (SLA) mode.
  • C. Port2 has the highest member priority.
  • D. FortiGate updated the outgoing interface list on the rule so it prefers port2.

Answer: A,D


NEW QUESTION # 38
Which statement about using BGP for ADVPN is true?

  • A. You must configure BGP communities.
  • B. You must configure AS path prepending.
  • C. IBGP is preferred over EBGP, because IBGP preserves next hop information.
  • D. You must use BGP to route traffic for both overlay and underlay links.

Answer: C

Explanation:
ADVPN is a technology that allows dynamic creation of IPsec tunnels between branch sites without requiring pre-configured policies or keys. BGP is a routing protocol that can be used to exchange routes between ADVPN peers. IBGP is a type of BGP that runs between routers in the same autonomous system (AS), while EBGP is a type of BGP that runs between routers in different ASes. IBGP is preferred over EBGP for ADVPN, because IBGP preserves the next hop information of the routes, which is needed to establish the IPsec tunnels. EBGP changes the next hop information to the EBGP peer address, which may not be reachable by the ADVPN peers. Therefore, using IBGP for ADVPN avoids the need to configure additional static routes or redistribute routes between BGP and another routing protocol. References = ADVPN with BGP as the routing protocol, ADVPN, SD-WAN self-healing with BGP, Technical Tip: ADVPN with BGP as the routing protocol The statement that IBGP is preferred over EBGP for ADVPN because IBGP preserves next hop information (D) is true. In a typical ADVPN deployment, it's beneficial to maintain next hop information across the network to ensure proper routing and optimal path selection. References: This understanding comes from my knowledge of Fortinet's SD-WAN and ADVPN configurations, where BGP's behavior in terms of next hop preservation is a key consideration.


NEW QUESTION # 39
Refer to the exhibit.

The exhibit shows the BGP configuration on the hub in a hub-and-spoke topology. The administrator wants BGP to advertise prefixes from spokes to other spokes over the IPsec overlays, including additional paths. However, when looking at the spoke routing table, the administrator does not see the prefixes from other spokes and the additional paths.
Based on the exhibit, which three settings must the administrator configure inside each BGP neighbor group so spokes can learn other spokes prefixes and their additional paths? (Choose three.)

  • A. Set additional-path to send
  • B. Enable soft-reconfiguration
  • C. Enable route-reflector-client
  • D. Set advertisement-interval to the number of additional paths to advertise
  • E. Set adv-additional-path to the number of additional paths to advertise

Answer: A,C,E


NEW QUESTION # 40
Refer to the exhibit.

The exhibit shows the SD-WAN rule status and configuration.
Based on the exhibit, which change in the measured latency will make T_MPLS_0 the new preferred member?

  • A. When T_MPLS_0 has a latency of 100 ms.
  • B. When T_INET_0_0 and T_MPLS_0 have the same latency.
  • C. When T_N1PLS_0 has a latency of 80 ms.
  • D. When T_INET_0_0 has a latency of 250 ms.

Answer: C


NEW QUESTION # 41
Within IPsec tunnel templates available on FortiManager. which template will you use to configure static tunnels for a hub and spoke topology?

  • A. IPsec_Fortinet_Recommended
  • B. Hub_IPsec_Recommended
  • C. Static_IPsec_Recommended
  • D. Branch_IPsec_Recommended

Answer: D

Explanation:
Recommended templates will allow you to prepare a template for IPsec tunnels using Fortinet recommended settings for phase1 and phase2 parameters.
* The IPsec_Fortinet_Recommended template defines a template for a static point-to-point tunnel
* The BRANCH_IPsec_Recommended template defines a template for a static tunnel (with a known remote IP address)
* The HUB_IPsec_Recommended template defines a template for a dynamic tunnel (an IPsec hub for dial-up tunnels)


NEW QUESTION # 42
Refer to the exhibit.

Which conclusion about the packet debug flow output is correct?

  • A. The original traffic exceeded the maximum bandwidth configured in the traffic shaper, and the packet was dropped.
  • B. The original traffic exceeded the maximum bandwidth of the outgoing interface, and the packet was dropped.
  • C. The reply traffic exceeded the maximum bandwidth configured in the traffic shaper, and the packet was dropped.
  • D. The original traffic exceeded the maximum packets per second of the outgoing interface, and the packet was dropped.

Answer: A


NEW QUESTION # 43
Which statement about using BGP for ADVPN is true?

  • A. You must configure BGP communities.
  • B. You must configure AS path prepending.
  • C. IBGP is preferred over EBGP, because IBGP preserves next hop information.
  • D. You must use BGP to route traffic for both overlay and underlay links.

Answer: C

Explanation:
ADVPN is a technology that allows dynamic creation of IPsec tunnels between branch sites without requiring pre-configured policies or keys. BGP is a routing protocol that can be used to exchange routes between ADVPN peers. IBGP is a type of BGP that runs between routers in the same autonomous system (AS), while EBGP is a type of BGP that runs between routers in different ASes. IBGP is preferred over EBGP for ADVPN, because IBGP preserves the next hop information of the routes, which is needed to establish the IPsec tunnels. EBGP changes the next hop information to the EBGP peer address, which may not be reachable by the ADVPN peers. Therefore, using IBGP for ADVPN avoids the need to configure additional static routes or redistribute routes between BGP and another routing protocol. Reference = ADVPN with BGP as the routing protocol, ADVPN, SD-WAN self-healing with BGP, Technical Tip: ADVPN with BGP as the routing protocol The statement that IBGP is preferred over EBGP for ADVPN because IBGP preserves next hop information (D) is true. In a typical ADVPN deployment, it's beneficial to maintain next hop information across the network to ensure proper routing and optimal path selection. Reference: This understanding comes from my knowledge of Fortinet's SD-WAN and ADVPN configurations, where BGP's behavior in terms of next hop preservation is a key consideration.


NEW QUESTION # 44
In a hub-and-spoke topology, what are two advantages of enabling ADVPN on the IPsec overlays? (Choose
two.)

  • A. It enables spokes to bypass the hub during shortcut negotiation.
  • B. It provides the benefits of a full-mesh topology in a hub-and-spoke network.
  • C. It enables spokes to establish shortcuts to third-party gateways.
  • D. It provides direct connectivity between spokes by creating shortcuts.

Answer: B,D


NEW QUESTION # 45

Two hub-and-spoke groups are connected through a site-to-site IPsec VPN between Hub 1 and Hub 2.
The administrator configured ADVPN on both hub-and-spoke groups.
Which two outcomes are expected if a user in Toronto sends traffic to London? (Choose two.)

  • A. The first packets from Toronto to London are routed through Hub 1 then to Hub 2.
  • B. Toronto needs to establish a site-to-site tunnel with Hub 2 to bypass Hub 1.
  • C. London generates an IKE information message that contains the Toronto public IP address.
  • D. Traffic from Toronto to London triggers the dynamic negotiation of a direct site-to-site VPN.

Answer: A,D


NEW QUESTION # 46
Refer to the exhibit.

Which configuration change is required if the responder FortiGate uses a dynamic routing protocol to exchange routes over IPsec?

  • A. exchange-interface-ip must be enabled.
  • B. add-route must be disabled.
  • C. mode-cfg must be enabled.
  • D. type must be set to static.

Answer: B


NEW QUESTION # 47
Refer to the exhibit.

Based on the exhibit, which statement about FortiGate re-evaluating traffic is true?

  • A. Changes have been made on firewall policy ID 1 on FortiGate.
  • B. The type of traffic defined and allowed on firewall policy ID 1 is UDP.
  • C. FortiGate has terminated the session after a change on policy ID 1.
  • D. Firewall policy ID 1 has source NAT disabled.

Answer: A


NEW QUESTION # 48
In the default SD-WAN minimum configuration, which two statements are correct when traffic matches the
default implicit SD-WAN rule? (Choose two )

  • A. An absolute SD-WAN rule was defined and matched traffic.
  • B. Matched traffic failed RPF and was caught by the rule.
  • C. The FIB lookup resolved interface was the SD-WAN interface.
  • D. Traffic has matched none of the FortiGate policy routes.

Answer: C,D


NEW QUESTION # 49
Refer to the exhibits.
Exhibit A

Exhibit B -

Exhibit A shows the configuration for an SD-WAN rule and exhibit B shows the respective rule status, the routing table, and the member status.
The administrator wants to understand the expected behavior for traffic matching the SD-WAN rule.
Based on the exhibits, what can the administrator expect for traffic matching the SD-WAN rule?

  • A. The traffic will be routed over T_INET_1_0.
  • B. The traffic will be routed over T_INET_0_0.
  • C. The traffic will be routed over T_MPLS_0.
  • D. The traffic will be load balanced across all three overlays.

Answer: A


NEW QUESTION # 50
......


Fortinet NSE7_SDW-7.2 Exam Syllabus Topics:

TopicDetails
Topic 1
  • SD-WAN Configuration: This topic assesses skills of Fortinet network and security professionals in setting up basic SD-WAN environments, including configuring Direct Internet Access (DIA), SD-WAN Members, and Performance Service Level Agreements (SLAs). Proficiency here ensures the ability to design efficient and resilient SD-WAN configurations.
Topic 2
  • Rules and Routing: Understanding SD-WAN Rules and Routing is crucial for directing traffic effectively. This topic of the NSE7_SDW-7.2 exam evaluates the capabilities of Fortinet network and security professionals to configure SD-WAN rules and routing.
Topic 3
  • SD-WAN Troubleshooting: Troubleshooting SD-WAN issues, including rules, routing, and ADVPN, is vital for maintaining network reliability. This section of the Fortinet NSE 7 - SD-WAN 7.2 exam tests the ability to diagnose and resolve SD-WAN problems using diagnostic commands and monitoring tools, ensuring robust and uninterrupted network operations.
Topic 4
  • SD-WAN Overlay Design and Best Practices: It focuses on the deployment of hub-and-spoke IPsec topologies and configuring ADVPN. Proficiency in this topic ensures that Fortinet network and security professionals can implement effective and reliable SD-WAN overlays tailored to organizational needs.
Topic 5
  • Centralized Management: This area focuses on deploying and managing SD-WAN through FortiManager, including using IPsec templates and SD-WAN Overlay Templates. Mastery here demonstrates the abilities of Fortinet network and security professionals to streamline SD-WAN configuration, enhance security, and maintain consistent policies across multiple sites.

 

Latest 100% Passing Guarantee - Brilliant NSE7_SDW-7.2 Exam Questions PDF: https://www.guidetorrent.com/NSE7_SDW-7.2-pdf-free-download.html

NSE7_SDW-7.2 Certification – Valid Exam Dumps Questions Study Guide: https://drive.google.com/open?id=1EeGnsEb7tpVgaDqlcCuJjAQUWYP7DBYB