2026 Realistic GuideTorrent INST1-V8 Dumps PDF - 100% Passing Guarantee
Free BICSI INST1-V8 Exam Questions and Answer
NEW QUESTION # 60
What grade of plywood is recommended for use with ICT systems?
- A. B/C
- B. A/C
- C. C/D
- D. A/D
Answer: B
NEW QUESTION # 61
Which of the following are typically used to support cables between a cable tray and work area outlets?
- A. Innerduct
- B. Pipe hanger
- C. Trapeze
- D. J-Hook
Answer: D
NEW QUESTION # 62
What is the bend radius requirement for optical fiber cable when the cable is at rest?
- A. 15 times the cables outside diameter
- B. 20 times the cables outside diameter
- C. 10 times the cables outside diameter
Answer: C
NEW QUESTION # 63
Which type of cabling is installed between a main cross connect and a horizontal cross connect?
- A. Horizontal
- B. Second-level backbone
- C. First-level backbone
Answer: C
NEW QUESTION # 64
If you are working on a catwalk, you are required to wear _____?
- A. Full body harness and two lanyards
- B. Nothing, your fine on the catwalk
- C. Safety belt
Answer: A
NEW QUESTION # 65
What is the required physical topology for a SCS?
- A. Ring
- B. Star
- C. Tree
- D. Bus
Answer: B
NEW QUESTION # 66
What is the maximum allowable horizontal cable length?
- A. 90 m (295')
- B. 30 m (100')
- C. 50 m (164')
- D. 10 m (33 ')
Answer: A
NEW QUESTION # 67
Which of the following tools is a low-cost cable verifier that can be used to test for opens, shorts, crossed pairs, and miswires in 4- pair cables?
- A. Qualification tester
- B. Telephone test set
- C. TDR
- D. Wire map tester
Answer: D
NEW QUESTION # 68
Which of the following attachment methods does BICSI recommend for attaching coaxial connectors to coaxial cable?
- A. Crimp
- B. Push-on
- C. Compression
- D. Screw-on
Answer: C
NEW QUESTION # 69
What is the minimum number of consolidation points that should serve an open office furniture cluster?
- A. 0
- B. 1
- C. 2
- D. 3
Answer: C
NEW QUESTION # 70
Light pulses in optical fiber cables are subjected to a loss in power as the light pulses travel along the optical fiber. Which of the following terms is used to describe this phenomenon?
- A. Grounding
- B. Frequency
- C. Attenuation
- D. Crosstalk
Answer: C
NEW QUESTION # 71
You are pre-terminating cable. Where should the labels be placed?
- A. Near end
- B. Far end
- C. Both ends
Answer: C
NEW QUESTION # 72
What is the minimum inside bend radius for balanced twisted pair (multi-pair) cable?
- A. 10 times the outside cable diameter
- B. 25 mm (1")
- C. 50 mm (2")
- D. 6 times the outside cable diameter
Answer: A
NEW QUESTION # 73
Which of the following is used to connect cabinets to the nearest SBB?
- A. RBB
- B. BBC
- C. TEBC
- D. TBB
Answer: C
NEW QUESTION # 74
What is the primary purpose of the telecommunications bonding infrastructure?
- A. Equalize potentials between metallic surfaces and equipment within entrance facilities
- B. Improve the performance of the installed telecommunications equipment
- C. Provide backup power to the telecommunications equipment when primary power to the equipment fails.
Answer: A
NEW QUESTION # 75
Which phase of testing includes documenting the test results?
- A. Phase 1
- B. Phase 2
- C. Phase 3
Answer: C
NEW QUESTION # 76
Volts are measurement of _______?
- A. Electrical pressure
- B. Sound waves
- C. Electromagnetic radiation
- D. Light reflection
Answer: A
NEW QUESTION # 77
Which of the following items may be used as a substitute device for a pulling eye?
- A. Innerduct
- B. D rings
- C. Fan-out kit
- D. Wire mesh grip
Answer: D
NEW QUESTION # 78
Which of the following tend to cause sheath damage during cable pulling?
- A. RMC/IMC
- B. FMC/FMT
- C. EMT/ENT
Answer: B
NEW QUESTION # 79
Which of the following fire ratings refers to the time period that the unexposed surface of a firestop assembly does not exceed 180 degrees C (325 degrees F) above its initial temperature?
- A. E rating
- B. FH rating
- C. S rating
- D. FT rating
Answer: D
NEW QUESTION # 80
Which of the following steps should be performed first when terminating a coaxial cable?
- A. Verify connector type
- B. Cut the cable
- C. Fold back the braiding
- D. Strip the cable
Answer: A
NEW QUESTION # 81
What is the characteristic impedance of Series-6 coaxial cable?
- A. 25 ohms
- B. 75 ohms
- C. 50 ohms
- D. 100 ohms
Answer: B
NEW QUESTION # 82
......
Verified INST1-V8 dumps Q&As Latest INST1-V8 Download: https://www.guidetorrent.com/INST1-V8-pdf-free-download.html
Updated 100% Cover Real INST1-V8 Exam Questions - 100% Pass Guarantee: https://drive.google.com/open?id=1VpkdyIywwBUYXYxxdpzyombSuwyd_Bqk